Lectrosonics SPNDNT Manuel d'utilisateur télécharger pdf (Page 23)

Installation and Quick Start Guide

Rio Rancho, NM

Set up the inputs for the microphones connected to the

SPNTrio. Adjust the gain so the level is close to 0dBu

during normal speech.

Select SPNTrio Inputs tab

Route the inputs as follows:

• In1toMix1andMix5

• In2toMix2andMix5

In this example, Mixes 1 and 2 are routed to the local

sound system in a mix-minus pattern. Mix 5 delivers

the audio from the local microphones into the Dante

network.

Select SPNTrio Matrix tab

Route the Dante network channels in the SPNDNT as

follows:

• In1toMix3

• In2toMix4

This will provide the audio source from the network to

the local sound system.

Select SPNDNT

Matrix tab

Select the signal sources for the output channels on

the SPNTrio to feed the local sound system.

Select SPNTrio

Output Source tab

Output Channel Signal Source

1 Mix 2

2 Mix 1

3 Mix 3

4 Mix 4

Outputs 1 and 2 are conﬁgured in a “criss cross” man-

ner to imply that there is a mix-minus arrangement in

the local sound system.

Outputs 3 and 4 deliver the audio from the other two

ASPEN systems on the network into the local sound

system.

(see next page)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Lectrosonics SPNDNT Manuel d'utilisateur Page 23