Lectrosonics UCR201 Manuel d'utilisateur télécharger pdf (Page 14)

UCR201

REPLACING THE BATTERY

Lift and open the bottom battery door cover with your

thumb, rotate the door clockwise until it is perpendicular

with the case and allow the battery to fall out of the

compartment into your hand. Retaining pins will prevent

you from opening too far. It is difficult to install the

battery backwards. Observe the large and small holes in

the battery contact pad before inserting a new battery.

Insert the contact end of the battery first, making sure

the contacts are aligned with the holes in the contact

pad, and then swing the door closed. You will feel it snap

into place when it is fully closed.

CAUTION

Lithium batteries will expand and swell if allowed to go into a deep

discharge. Be sure to remove lithium batteries as soon as the display

starts flashing. If lithium batteries are allowed to fully discharge

while still inside the battery compartment, they may be very difficult

to remove. Stuck lithium batteries can be avoided by removing the

battery label wrapping before use. This will allow the battery to

swell but will still leave enough room in the compartment for the

battery to fall out normally.

To open the battery

compartment door, push the

door up and away from the case

with your thumb, then swing

open.

Professional Audio Products Since 1971

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Lectrosonics UCR201 Manuel d'utilisateur Page 14