Lectrosonics SMQ Manuel d'utilisateur

SM, SMD, SMQ INSTRUCTION MANUAL Super Miniature Belt-Pack Transmitter With Digital Hybrid Wireless™ Technology Fill in for your records

SM Setting Transmitter Operating Frequency The Operating Frequency of the SM can be displayed either in MHz or as a two-digit hexadecimal

Super-Minature Belt Pack Transmitter Locking or Unlocking the Control Panel The Lock mode protects the transmitter from accidental changes to i

SM 5-Pin Input Jack Wiring The wiring diagrams included in this section represent the basic wiring necessary for the most common types of microp

Super-Minature Belt Pack Transmitter Wiring Hookups for Different Sources In addition to the wiring hookups illustrated below, Lectrosonics makes a n

SM Troubleshooting Before going through the following chart, be sure that you have a good battery in the transmitter. It is important that you fol

Super-Minature Belt Pack Transmitter SYMPTOM POSSIBLE CAUSE HISS AND NOISE -- AUDIBLE DROPOUTS 1) Transmitter gain (audio level) far too low

SM LECTROSONICS, INC. 16

Super-Minature Belt Pack Transmitter Specifications and Features Operating frequencies: Block 21 537.600 - 563.100 Block 22 563.200 - 588.700 Blo

SM LECTROSONICS, INC. 18

Super-Minature Belt Pack Transmitter Service and Repair If your system malfunctions, you should attempt to correct or isolate the trouble

SM Thank you for selecting the Lectrosonics SM ultra-miniature transmitter. The unique design provides several distinct features for professional a

LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provid

Super-Minature Belt Pack Transmitter Table of Contents General Technical Description ...

SM General Technical Description Introduction The SM transmitter uses ±75 kHz wide deviation for an extremely high signal to noise ratio,

Super-Minature Belt Pack Transmitter actual roll-off frequency will vary somewhat according to the low frequency response of the mic capsu

SM Controls and Functions Modulation LEDs Control Panel LCD Battery Compartment Cover Plate Antenna Battery Audio Compartment Input Jack

Super-Minature Belt Pack Transmitter SM Screen Selections Six screens are used to set up and operate the SM. These screens are used

SM Standby Mode Quickly pressing both the AUDIO and FREQ buttons from rF OFFa power off condition places the unit in Standby Mode. In

Super-Minature Belt Pack Transmitter Operating Instructions Power Up and Boot Sequence 1) Ensure that a good battery is installed in the uni