Lectrosonics Venue (Narrowband) Manuel d'utilisateur télécharger pdf (Page 10)

 

   

  

      

Venue Narrowband Receiver

Powering On and Off

When the Venue receiver is ﬁrst powered up the LCD

will show the ﬁrmware revision and the tuning range

of the host assembly for a few seconds as the boot

sequence begins.

The receiver modules are then detected, which takes a

few seconds.

When detection is complete, the LCD will brieﬂy display

the frequency blocks of the installed modules.

At the end of the boot sequence the LCD changes to an

overview screen of all six channels.

In this example of the overview screen, six receiver

modules are installed, but no transmitters are in use.

During operation, the overview screen will display the

following information for the channels in use:

• Audio level

• RF level

• Diversity antenna phase activity

• Pilot tone status

• Transmitter battery status

Diversity activity

Audio level

(in switched mode)

No module

installed in

channel 6

Pilot tone status RF level

Transmitter

battery gauge

In this example, channels 1 and 4 are being used; chan-

nels 2, 3 and 4 have a receiver module installed, but the

matching transmitters are not turned on. Channel 6 has

no receiver module installed.

To turn the power off, press and hold the red power

switch for several seconds. The LCD will display a mes-

sage brieﬂy then power down.

Navigating the LCD Menus

and Screens

Front panel controls provide access to screens and

menus for setup. The Function Button, Back Button, Re-

ceiver Select buttons and the MENU/SELECT control

are used to make selections and adjust parameters.

Function Button (labeled by the LCD)

Back Button Receiver Select MENU/SELECT

Buttons 1-6 Control

The overview screen displays a summary of all six

channels, as shown above. This is a good starting point

for navigating to any menu or setup screen. Pressing

the BACK button repeatedly from any menu or screen

will eventually return to this overview screen.

From the overview screen, pressing one of the six

Receiver Select Buttons will switch to the detail screen

for the associated receiver module to display all current

settings, levels and status.

Pilot Tone Transmitter Frequency

Monitoring Status Select Switch Settings

Receiver Module Operating

Location Frequency

RF Signal

Strength

Antenna Phase

Tuning Mode

Transmitter

Battery Gauge

TV Channel

Audio Level Meter

LECTROSONICS, INC.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Lectrosonics Venue (Narrowband) Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Lectrosonics Venue (Narrowband)