Lectrosonics Venue (Narrowband) Manuel d'utilisateur télécharger pdf (Page 12)

  

   

 

     

  

   

 

      



       

Venue Narrowband Receiver

System Setup with the LCD

It is generally best to complete these steps in the se-

quence shown.

• Select compatibility modes

• Select Smart Noise Reduction mode

(for Digital Hybrid Compat Mode only)

• Select diversity modes

• Find clear channels and set transmitters to

match the receivers

• Adjust audio output level

• Select audio signal phase

• Select transmitter battery monitoring mode

• Control panel lockout

Selecting Compatibility Modes

Navigate to the Compat setup screen.

Six compatibility modes are available to match various

transmitter types. In this example, the Digital Hybrid

compatibility mode is selected for receiver module 1.

Press the Receiver Select button for each module and

rotate the MENU/SELECT control to select the mode.

The following modes are available:

Compat

Setup Mode Description

Dig. Hybrid Lectrosonics Digital Hybrid (HYB)

Mode 3 Mode 3 (M.3) (call for details)

200 Series Lectrosonics 200 Series (200)

100 Series Lectrosonics 100 Series (100)

IFB Lectrosonics IFB Series (IFB)

Mode 6 Mode 6 (M.6) (call for details)

Shortcut: Press and hold the Receiver Select

button under the selected module (module 1 in

the example above) then press the buttons under

the other modules that are to be set to the same

mode.

If you are using Digital Hybrid transmitters, set them

and the matching receiver modules to the Dig. Hybrid

mode for best performance.

Selecting the Noise Reduction Mode

When the Compat Mode is set to Digital Hybrid, three

settings are available that affect the high frequency

audio content and noise:

• NORMAL (factory default) applies a moderate

amount of noise reduction, dramatically reducing

hiss with virtually no discernible side effects.

• FULL applies more aggressive noise reduction with

transparency superior to the noise reduction system

used for many years in the earlier Lectrosonics

wide deviation analog systems.

• OFF applies no noise reduction for complete trans-

parency.

Navigate to the SmartNR setup screen.

Select the receiver module with Receiver Select Button

and rotate the MENU/SELECT control to the desired

mode. Listen to the audio signal as you rotate the knob

and select the mode that best ﬁts the situation.

Note: If the selected Receiver Module is part of

a ratio or frequency diversity pair, the mode will

automatically be set for both receiver modules in

the pair.

When any Compat Mode other than Dig. Hybrid is se-

lected, FIXED will automatically be selected.

In this example, receiver modules 4, 5 and 6 are set to

the FIXED mode with no adjustment available.

Selecting Diversity Modes

Navigate to the DivMode setup screen.

LECTROSONICS, INC.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Lectrosonics Venue (Narrowband) Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Lectrosonics Venue (Narrowband)